The Great Beyond
Bell Curve Roles
Bell Curve Rolls
Here’s perhaps the most fundamental variant to the d20 rules: Don’t use a d20! Instead, roll 3d6 whenever you would roll a d20, applying bonuses and penalties normally. The possible results when rolling 3d6 (or any other multiple dice) form a bell curve—that is, a range of odds that favors average results much more than extreme results.
Metagame Analysis: The Bell Curve
In general, this variant leads to a grittier d20 game, because there will be far fewer very good or very bad rolls. Not only can you no longer roll 1, 2, 19 or 20, but most rolls will be clustered around the average of 10.5. With a d20, every result is equally likely; you have a 5% chance of rolling an 18 and a 5% chance of rolling a 10. With 3d6, there’s only one possible combination of dice that results in an 18 (three sixes, obviously), but there are twenty-four combinations that result in a 10. Players used to the thrill of rolling high and the agony of a natural 1 will get that feeling less often—but it may be more meaningful when it does happen. Good die rolls are a fundamental reward of the game, and it changes the character of the game when the rewards are somewhat stronger but less frequent.
Game balance shifts subtly when you use the bell curve variant. Rolling 3d6 gives you a lot more average rolls, which favors the stronger side in combat. And in the d20 game, that’s almost always the PCs. Many monsters—especially low-CR monsters encountered in groups—rely heavily on a lucky shot to damage PCs. When rolling 3d6, those lucky shots are fewer and farther between. In a fair fight when everyone rolls a 10, the PCs should win almost every time. The bell curve variant adheres more tightly to that average (which is the reason behind the reduction in CR for monsters encountered in groups).
Another subtle change to the game is that the bell curve variant awards bonuses relatively more and the die roll relatively less, simply because the die roll is almost always within a few points of 10. A character’s skill ranks, ability scores, and gear have a much bigger impact on success and failure than they do in the standard d20 rules.
Rules For Rolling
This system requires several changes to how rolls are made.
Automatic Successes and Failures
Automatic successes (for attack rolls and saves) happen on a natural 18, and automatic failures on a natural 3. Neither occurs as often as in standard d20 (less than 1/2% of the time as opposed to 5% of the time).
Taking 20 and taking 10
You can’t take 20 using the bell curve variant. Instead, you have two new options: You can take 16, which makes the task take ten times as long, or you can take 18, which makes the task take one hundred times as long. As with the rules for taking 20, you can only take 16 and 18 when you have plenty of time, when you aren’t distracted, and when the task carries no consequences for failure. For a check that normally requires a standard action, taking 16 uses up 1 minute and taking 18 uses up 10 minutes.
The rules for taking 10 remain unchanged.
|Old Threat Range||New Threat Range|
Because it’s no longer possible to roll a natural 19 or 20, the threat ranges of weapons change in the bell curve variant. Refer to the following table.
With the bell curve variant, the narrowest threat range becomes slightly more narrow (4.6% rather than 5%), and the new 14-18 range (16%) falls between the old 18-20 and 17-20 ranges. But because the Improved Critical feat and the keen edge spell double threat ranges, characters still improve their weapons in every case, despite the flat spot on the table.
There’s no table entry for a threat range of 16-20 because no combination weapons, feats, and magic can attain it in the standard d20 rules.
Monster Challenge Ratings
Any time creatures are encountered in groups of four or more, reduce their CR by 1. For example, a single troll is CR 5, and two trolls are CR 5 each (and thus a EL 7 encounter). But four trolls are only CR 4 each (making a EL 8 encounter).
Monsters with fractional CRs move down to the next lowest fraction when encountered in groups of four or more; the goblin (ordinarily CR 1/2) becomes CR 1/3, for example.
The Luck Domain
The granted power of the Luck domain changes, because simple rerolls aren’t as useful in the bell curve variant as they are in the standard rules. When electing to reroll a result, a cleric with access to the Luck domain rolls a 4d6 for the reroll (instead of a 3d6), dropping the lowest die. For example, if you rolled 2, 5, 6 and 6, you would drop the 2 for a total of 17.
The Luck domain’s spells change as well, with auspicious odds replacing protection from energy at 3rd level and mass auspicious odds replacing break enchantment at 5th level.
|Components:||V, S, M, DF|
|Casting Time:||1 standard action|
|Duration:||1 minute/level; see text|
|Saving Throw:||Will negates (harmless)|
|Spell Resistance:||Yes (harmless)|
Whenever making an attack roll, saving throw, ability check, or skill check, the subject rolls 4d6 and drops the lowest single die roll from the total rather than rolling 3d6. If, on a single roll, all four die results are 1s, the spell immediately ends.
Material Component: A copper piece.
Auspicious Odds, Mass
|Range:||Close (25 + 5ft./2 levels)|
|Target:||One creature/three levels, no two of which can be more than 30 ft. apart|
|Duration:||1 round/level; see text.|
As auspicious odds, except that this spell affects multiple targets and the duration is shorter. If, on a single roll, all four die results are 1s, the spell immediately ends for that subject only, unless it’s the caster, in which case it ends for everyone.